![]() Only one conduit knockout is to be used for wiring. (See wiring diagrams on the following pages.) All wiring must be performed in accordance with NFPA 70/72 or CSA C 2.1 (Safety Standard for Electrical Installations, Canadian Electrical Code, Part I, Section 32). Mount the BAT-Fire using the guidelines listed below to meet UL 864/UL 1610/NFPA or ULC-S559/ULC-S304.Set up an account in the AlulaConnect portal.The BAT-Fire can be configured to provide dual path connectivity using Ethernet/broadband and cell or single path connectivity using either Ethernet/broadband or cell to Bosch Conettix D6100IPv6 receivers at the central station. ![]() 9th edition and earlier permitted this method for multiple protection zones. Note: for UL 864 10th edition, this configuration may only be used for panels with one input zone. (Refer to the Programming section describing how to set up a BAT-Fire input for FACP point capture.) ![]() A state change on a BAT-Fire monitored FACP point will be reported to the central station. BAT-Fire will continually monitor the state of the FACP points. In this topology, BAT-Fire inputs will be connected to the FACP points. The BAT-Fire provides inputs that can be used to monitor an FACP’s alarm, supervision, and trouble points. The BAT-Fire receives CID events from the FACP’s DACT and then relays the CID events to the central station receiver. BAT-Fire’s DACT phone interface connection provides phone line voltage, dial tone, ringback tone, and all required CID protocol signaling.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |